Kontron AT8402 CLI - Manual (Page 163)

AT8402 Utility Commands
Page 4 - 23 AT8402 CLI Reference Manual
4.4.11 show logging hosts
This command displays all configured logging hosts.
Format
show logging hosts
Mode Privileged EXEC
Host Index (Used for deleting hosts)
IP Address IP address of the logging host.
Severity Level The minimum severity to log to the specified address. The possible
values are emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), or debug (7).
Port Displays the server port number, which is the port on the local host
from which syslog messages are sent.
Host Status The state of logging to configured syslog hosts. If the status is disable,
no logging occurs.
4.4.12 show logging traplogs
This command displays SNMP trap events and statistics.
Format
show logging traplogs
Mode Privileged EXEC
Number of Traps Since Last Reset The number of traps since the last boot.
Trap Log Capacity The number of traps the system can retain.
Number of Traps Since Log Last Viewed The number of new traps since the com-
mand was last executed.
Log The log number.
System Time Up How long the system had been running at the time the trap was sent.
Trap
The text of the trap message.
4.4.13 clear board event-log
This command deletes all event-log records
Format
clear board event-log
Mode Privileged EXEC
4.4.14 show logging backtrace
This command displays the backtrace file last created. A backtrace file is created when
the application stops unexpectedly.
Format
show logging backtrace
Modes Privileged EXEC
4.4.15 show logging diag-report
This command displays the results of the last diagnostic run. The diagnostic results file
is created by a diagnostic run.