Kontron AT8402 CLI - Manual (Page 56)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 24
You should create the referenced VLAN before you create the protocol-based VLAN
except when you configure GVRP to create the VLAN.
Default none
Format
protocol vlan group all
<groupid>
Mode Global Config
2.3.19.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is
identified by this
<groupid>
.
Format
no protocol vlan group all
<groupid>
Mode Global Config
2.3.20 vlan pvid
This command changes the VLAN ID per interface.
Default 1
Format
vlan pvid
<1-4094>
Mode Interface Config
2.3.20.1 no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
no vlan pvid
Mode Interface Config
2.3.21 vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to
enabled. If tagging is enabled, traffic is transmitted as tagged frames. If tagging is
disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
vlan tagging
<1-4094>
Mode Interface Config
2.3.21.1 no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to
disabled. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a
valid VLAN identification number.
Format no vlan tagging <1-4094>
Mode Interface Config
2.3.22 vlan association subnet
This command associates a VLAN to a specific IP-subnet.