Kontron AT8402 CLI - Manual (Page 198)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 8
Default enabled
Format
transport output telnet
Mode Line Config
5.3.4.1 no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode Line Config
5.3.5 session-limit
This command specifies the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
Default
5
Format
session-limit
<0-5>
Mode Line Config
5.3.5.1 no session-limit
This command sets the maximum number of simultaneous outbound Telnet sessions to
the default value.
Format
no session-limit
Mode Line Config
5.3.6 session-timeout
This command sets the Telnet session timeout value.The timeout value unit of time is
minutes. A value of 0 indicates that a session remains active indefinitely.
Default
0
Format session-timeout <0-160>
Mode Line Config
5.3.6.1 no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value
unit of time is minutes.
Format
no session-timeout
Mode Line Config
5.3.7 telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can
be established. A value of 0 indicates that no Telnet connection can be established. The
range is 0-5.
Default
5
Format
telnetcon maxsessions
<0-5>