Kontron AT8402 CLI - Manual (Page 116)

Quality of Service (QoS) Commands AT8402
AT8402 CLI Reference Manual Page 3 - 4
Modes Global Config
Interface Config
3.1.4.1 no cos-queue min-bandwidth
This command restores the default for each queue's minimum bandwidth value.
Format
no cos-queue min-bandwidth
Modes Global Config
Interface Config
3.1.5 cos-queue strict
This command activates the strict priority scheduler mode for each specified queue.
Format
cos-queue strict
<queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes Global Config
Interface Config
3.1.5.1 no cos-queue strict
This command restores the default weighted scheduler mode for each specified queue.
Format
no cos-queue strict
<queue-id-1> [<queue-id-2> … <queue-id-
n>]
Modes Global Config
Interface Config
3.1.6 traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface
as a whole. Also known as rate shaping, traffic shaping has the effect of smoothing
temporary traffic bursts over time so that the transmitted traffic rate is bounded.
Format
traffic-shape
<bw>
Modes Global Config
Interface Config
3.1.6.1 no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes Global Config
Interface Config
3.1.7 show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic
classes for a specific interface. The
<
slot/port
>
parameter is optional and is only valid
on platforms that support independent per-port class of service mappings. If specified,
the 802.1p mapping table of the interface is displayed. If omitted, the most recent
global configuration settings are displayed. For more information, see 2.5
“Provisioning (IEEE 802.1p) Commands” on page 2 - 29.