Kontron AT8402 CLI - Manual (Page 43)

AT8402 Switching Commands
Page 2 - 11 AT8402 CLI Reference Manual
If you specify port-priority, this command sets the priority for this port within a
specific multiple spanning tree instance or the common and internal spanning tree
instance, depending on the
<mstid>
parameter, to the default value.
Format
no spanning-tree mst
<mstid> <cost | external-cost | port-prior-
ity>
Mode Interface Config
2.2.12 spanning-tree mst instance
This command adds a multiple spanning tree instance to the switch. The parameter
<mstid>
is a number within a range of 1 to 4094, that corresponds to the new instance
ID to be added. The maximum number of multiple instances supported by the switch is
4.
Default none
Format
spanning-tree mst instance
<mstid>
Mode Global Config
2.2.12.1 no spanning-tree mst instance
This command removes a multiple spanning tree instance from the switch and
reallocates all VLANs allocated to the deleted instance to the common and internal
spanning tree. The parameter
<mstid>
is a number that corresponds to the desired
existing multiple spanning tree instance to be removed.
Format
no spanning-tree mst instance <mstid>
Mode Global Config
2.2.13 spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance.
The parameter
<mstid> is a number that corresponds to the desired existing multiple
spanning tree instance. The priority value is a number within a range of 0 to 61440 in
increments of 4096.
If you specify 0 (defined as the default CIST ID) as the
<mstid>
, this command sets the
Bridge Priority parameter to a new value for the common and internal spanning tree.
The bridge priority value is a number within a range of 0 to 61440. The twelve least
significant bits are masked according to the 802.1s specification. This causes the
priority to be rounded down to the next lower valid priority.
Default 32768
Format spanning-tree mst priority <mstid> <0-61440>
Mode Global Config
2.2.13.1 no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance to
the default value. The parameter
<mstid> is a number that corresponds to the desired
existing multiple spanning tree instance.