Kontron AT8402 CLI - Manual (Page 170)

Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 30
4.7.6 sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default 1
Format
sntp unicast client poll-retry
<poll-retry>
Mode Global Config
4.7.6.1 no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
Format no sntp unicast client poll-retry
Mode Global Config
4.7.7 sntp multicast client poll-interval
This command will set the poll interval for SNTP multicast clients in seconds as a
power of two where <poll-interval> can be a value from 6 to 16.
Default 6
Format sntp multicast client poll-interval <poll-interval>
Mode Global Config
4.7.7.1 no sntp multicast client poll-interval
This command resets the poll interval for SNTP multicast clients to its default value.
Format
no sntp multicast client poll-interval
Mode Global Config
4.7.8 sntp server
This command configures an SNTP server (a maximum of three). The optional priority
can be a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
sntp server
<ipaddress> [<priority> [<version> [<portid>]]]
Mode Global Config
4.7.8.1 no sntp server
This command deletes an server from the configured SNTP servers.
Format no sntp server remove <ipaddress>
Mode Global Config
4.7.9 show sntp
This command is used to display SNTP settings and status.
Format
show sntp
Mode Privileged EXEC