Kontron AT8402 CLI - Manual (Page 220)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 30
5.9.3 tacacs-server timeout
Use the
tacacs-server timeout
command to set the timeout value for
communication with the TACACS+ servers. The <timeout> parameter has a range of
1-30 and is the timeout value in seconds.
Default
5
Format tacacs-server timeout <timeout>
Mode Global Config
5.9.3.1 no tacacs-server timeout
Use the no tacacs-server timeout command to restore the default timeout value for
all TACACS servers.
Format
no tacacs-server timeout
Mode Global Config
5.9.4 key
Use the
key
command in TACACS Configuration mode to specify the authentication
and encryption key for all TACACS communications between the device and the
TACACS server. This key must match the key used on the TACACS daemon. The
<key-string> parameter specifies the key name. For an empty string use “ ”. (Range: 0
- 128 characters).
Format
key
<key-string>
Mode TACACS Config
5.9.5 port
Use the
port
command in TACACS Configuration mode to specify a server port
number. The server <port-number> range is 0 - 65535.
Default
49
Format
port
<port-number>
Mode TACACS Config
5.9.6 priority
Use the
priority
command in TACACS Configuration mode to specify the order in
which servers are used, where 0 (zero) is the highest priority. The <priority>
parameter specifies the priority for servers. The highest priority is 0 (zero), and the
range is 0 - 65535.
Default
0
Format priority <priority>
Mode TACACS Config