Kontron AT8402 CLI - Manual (Page 44)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 12
If 0 (defined as the default CIST ID) is passed as the
<mstid>
, this command sets the
Bridge Priority parameter for the common and internal spanning tree to the default
value.
Format
spanning-tree mst priority
<mstid>
Mode Global Config
2.2.14 spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and a
VLAN so that the VLAN is no longer associated with the common and internal
spanning tree. The parameter
<mstid>
is a number that corresponds to the desired
existing multiple spanning tree instance. The
<vlanid>
corresponds to an existing
VLAN ID.
Format
spanning-tree mst vlan
<mstid> <vlanid>
Mode Global Config
2.2.14.1 no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and a
VLAN so that the VLAN is again be associated with the common and internal
spanning tree. The parameter
<mstid>
is a number that corresponds to the desired
existing multiple spanning tree instance. The
<vlanid>
corresponds to an existing
VLAN ID.
Format no spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
2.2.15 spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Default disabled
Format
spanning-tree port mode
Mode Interface Config
2.2.15.1 no spanning-tree port mode
This command sets the Administrative Switch Port State for this port to disabled.
Format no spanning-tree port mode
Mode Interface Config
2.2.16 spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
Default disabled
Format
spanning-tree port mode all
Mode Global Config