Kontron AT8402 CLI - Manual (Page 228)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 38
• filter (corner frequency 6Hz/cirener frequency 12Hz)
• select (primary clock/secondary clock)
• align (enable/disable)
• source (reference source)
Format set board pll switching {manual | holdover | loss-of-clock}
set board pll mode {normal | holdover | freerun}
set board pll select
{primary | secondary}
set board pll filter
{6Hz | 12Hz}
set board pll align {enable | disable}
set board pll source {clk1 | clk2 | clk3}
Mode Privileged Exec
5.16.4 show boardinfo clock bpl
This command shows the configuration of backplane clocks. The backplane clocks are
displayed with the state (enabled/disabled) and (if enabled) the mapped AMC source
with clock configuration attributes.
Format
show boardinfo clock bpl
Mode Privileged Exec
5.16.5 show boardinfo clock amc
This command shows the configuration of the AMC clocks. The AMC clocks are
displayed with the source (from carrier or AMC), state (enabled/disabled) and (if
enabled) the internal clock index with clock configuration attributes. If the source is the
AMC, it is checked whether an AMC is present (otherwise state is set to ‘not present’).
For source AMC the AMC is queried with the get clock state command and if the IPMI
command is not supported the state is set to ‘--’. For source Carrier the clock state is
queried from the local on-carrier device where the AMC clock is connected to.
Format
show boardinfo clock amc
Mode Privileged Exec
5.16.6 show boardinfo clock map
This command shows the AMC sources for the backplane clocks. If no source is
connected ‘--’ is displayed.
Format
show boardinfo clock map
Mode Privileged Exec
5.16.7 set board clock bpl
This command enables/disables a clock driver to the backplane.
Format
set board clock bpl
{clk1a | clk1b | clk2a | clk2b | clk3a | clk3b}
enable
set board clock bpl
{clk1a | clk1b | clk2a | clk2b | clk3a | clk3b}
disable
Mode Privileged Exec