Kontron AT8402 CLI - Manual (Page 81)

AT8402 Switching Commands
Page 2 - 49 AT8402 CLI Reference Manual
dropped. Therefore, the rate of multicast traffic will be limited to the configured
threshold.
Default disabled
Format
storm-control multicast all
Mode Global Config
2.11.7.1 no storm-control multicast all
This command disables multicast storm recovery mode for all interfaces.
Format
no storm-control multicast all
Mode Global Config
2.11.8 storm-control multicast all level
This command configures the multicast storm recovery threshold for all interfaces and
enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control multicast all level
<0-100>
Mode Global Config
2.11.8.1 no storm-control multicast all level
This command sets the multicast storm recovery threshold to the default value for all
interfaces and disables multicast storm recovery.
Format no storm-control multicast all level
Mode Global Config
2.11.9 storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is
enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast
(destination lookup failure) traffic ingressing on an interface increases beyond the
configured threshold, the traffic will be dropped. Therefore, the rate of unknown
unicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control unicast
Mode Interface Config
2.11.9.1 no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format
no storm-control unicast