Kontron AT8402 CLI - Manual (Page 74)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 42
server-timeout - The value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the authentication server. The supp-timeout must be a
value in the range 1 - 65535.
Default reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
Format dot1x timeout {{reauth-period <seconds>} | {quiet-period <sec-
onds>} | {tx-period <seconds>} | {supp-timeout <seconds>} |
{server-timeout <seconds>}}
Mode Interface Config
2.10.13.1 no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port to the default values. Depending on the token used, the
corresponding default values are set.
Format no dot1x timeout {reauth-period | quiet-period | tx-period | supp-
timeout | server-timeout}
Mode Interface Config
2.10.14 dot1x user
This command adds the specified user to the list of users with access to the specified
port or all ports. The
<user> parameter must be a configured user.
Format
dot1x user
<user> {<slot/port> | all}
Mode Global Config
2.10.14.1 no dot1x user
This command removes the user from the list of users with access to the specified port
or all ports.
Format no dot1x user <user> {<slot/port> | all}
Mode Global Config
2.10.15 users defaultlogin
This command assigns the authentication login list to use for non-configured users
when attempting to log in to the system. This setting is overridden by the
authentication login list assigned to a specific user if the user is configured locally. If
this value is not configured, users will be authenticated using local authentication only.
Format users defaultlogin <listname>
Mode Global Config