Kontron AT8402 CLI - Manual (Page 176)

Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 36
Format
no domain-name
Mode DHCP Pool Config
4.8.12 netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name
servers that are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one
command line. Servers are listed in order of preference (address1 is the most preferred
server, address2 is the next most preferred server, and so on).
Default none
Format
netbios-name-server
<address> [<address2>...<address8>]
Mode DHCP Pool Config
4.8.12.1 no netbios-name-server
This command removes the NetBIOS name server list.
Format no netbios-name-server
Mode DHCP Pool Config
4.8.13 netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host
Configuration Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid
types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format
netbios-node-type
<type>
Mode DHCP Pool Config
4.8.13.1 no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
4.8.14 next-server
This command configures the next server in the boot process of a DHCP client.The
<address> parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
Default inbound interface helper addresses