Kontron AT8402 CLI - Manual (Page 135)

AT8402 Quality of Service (QoS) Commands
Page 3 - 23 AT8402 CLI Reference Manual
specified for this command, a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface,
whereas the 'Global Config' mode setting is applied to all interfaces. The 'Interface
Config' mode command is only available on platforms that support independent per-
port class of service queue configuration.
Format
mac access-group
<name>
in
[sequence <1-4294967295>]
Modes Global Config
Interface Config
3.7.4.1 no mac access-group
This command removes a MAC ACL identified by
<name>
from the interface in a
given direction.
Format
no mac access-list
<name>
in
Modes Global Config
Interface Config
3.7.5 show mac access-lists
This command displays a MAC access list and all of the rules that are defined for the
MAC ACL. Use the [name] parameter to identify a specific MAC ACL to display.
Format
show mac access-lists
[name]
Mode Privileged EXEC
Rule Number The ordered rule number identifier defined within the MAC ACL.
Action
The action associated with each rule. The possible values are Permit or
Deny.
Source MAC Address The source MAC address for this rule.
Destination MAC Address The destination MAC address for this rule.
Ethertype
The Ethertype keyword or custom value for this rule.
VLAN ID The VLAN identifier value or range for this rule.
COS The COS (802.1p) value for this rule.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
3.8 IP Access Control List (ACL) Commands
This section describes the commands you use to configure IP ACL settings. IP ACLs
ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply to IP ACLs:
•
FASTPATH software does not support IP ACL configuration for IP packet frag-
ments.
• The maximum number of ACLs you can create is 100, regardless of type.