Kontron AT8402 CLI - Manual (Page 98)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 66
Format
show igmpsnooping mrouter vlan
<slot/port>
Mode Privileged EXEC
Interface The port on which multicast router information is being displayed.
VLAN ID The list of VLANs of which the interface is a member.
2.15.12 show mac-address-table igmpsnooping
This command displays the IGMP Snooping entries in the MFDB table.
Format show mac-address-table igmpsnooping
Mode Privileged EXEC
MAC Address A multicast MAC address for which the switch has forwarding or fil-
tering information. The format is two-digit hexadecimal numbers that
are separated by colons, for example 01:23:45:67:89:AB. In an IVL
system the MAC address is displayed as a MAC address and VLAN
ID combination of 8 bytes.
Type The type of the entry, which is either static (added by the user) or
dynamic (added to the table as a result of a learning process or proto-
col).
Description The text description of this multicast table entry.
Interfaces The list of interfaces that are designated for forwarding (Fwd:) and fil-
tering (Flt:).
2.16 Port Security Commands
This section describes the command you use to configure Port Security on the switch.
Port security, which is also known as port MAC locking, allows you to secure the
network by locking allowable MAC addresses on a given port. Packets with a matching
source MAC address are forwarded normally, and all other packets are discarded.
NOTE: To enable the SNMP trap specific to port security, see 5.6.8 “snmp-
server enable traps violation” on page 5 - 18.
2.16.1 port-security
This command enables port locking at the system level (Global Config) or port level
(Interface Config)
Default disabled
Format
port-security
Modes Global Config
Interface Config
2.16.1.1 no port-security
This command disables port locking for one (Interface Config) or all (Global Config)
ports.
Format no port-security