Kontron AT8402 CLI - Manual (Page 215)

AT8402 Management Commands
Page 5 - 25 AT8402 CLI Reference Manual
Format
no radius server host
{auth | acct} <ipaddress>
Mode Global Config
5.8.3 radius server key
This command is used to configure the shared secret between the RADIUS client and
the RADIUS accounting / authentication server. Depending on whether the 'auth' or
'acct' token is used, the shared secret is configured for the RADIUS authentication or
RADIUS accounting server. The IP address provided must match a previously
configured server. When this command is executed, the secret is prompted.
NOTE: The secret must be an alphanumeric value not exceeding 16 charac-
ters.
Format radius server key {auth | acct} <ipaddr>
Mode Global Config
5.8.4 radius server msgauth
This command enables the message authenticator attribute for a specified server.
Format
radius server msgauth <ipaddr>
Mode Global Config
5.8.4.1 no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
no radius server msgauth <ipaddr>
Mode Global Config
5.8.5 radius server primary
This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. You can
configure up to three servers on each client. Only one of these servers can be
configured as the primary. If a primary server is already configured prior to this
command being executed, the server specified by the IP address specified used in this
command will become the new primary server. The IP address must match that of a
previously configured RADIUS authentication server.
Format
radius server primary
<ipaddr>
Mode Global Config
5.8.6 radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted
when no response is received from the RADIUS server. The retries value is an integer
in the range of 1 to 15.
Default
4
Format radius server retransmit <retries>
Mode Global Config