10 storm-control unicast level, 11 storm-control unicast all, 12 storm-control unicast all level – Kontron AT8402 CLI User Manual
Page 82: 12 storm-control unicast all level - 50, Switching commands at8402
Switching Commands
AT8402
AT8402 CLI Reference Manual
Page 2 - 50
Mode
Interface Config
2.11.10
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface and
enables unicast storm recovery. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.This command also enables unicast storm recovery mode for an
interface.
Default
5
Format
storm-control unicast level
<0-100>
Mode
Interface Config
2.11.10.1
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an
interface and disables unicast storm recovery.
Format
no storm-control unicast level
Mode
Interface Config
2.11.11
storm-control unicast all
This command enables unicast storm recovery mode for all interfaces. If the mode is
enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast
(destination lookup failure) traffic ingressing on an interface increases beyond the
configured threshold, the traffic will be dropped. Therefore, the rate of unknown
unicast traffic will be limited to the configured threshold.
Default
disabled
Format
storm-control unicast all
Mode
Global Config
2.11.11.1
no storm-control unicast all
This command disables unicast storm recovery mode for all interfaces.
Format
no storm-control unicast all
Mode
Global Config
2.11.12
storm-control unicast all level
This command configures the unicast storm recovery threshold and enables unicast
storm recovery for all interfaces. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.