AERCO RECON 1000 - Manual (Page 17)

RECON Water Heaters Installation, Operation & Maintenance Manual
CHAPTER 2 – INSTALLATION
OMM-0103_0A AERCO International, Inc.  100 Oritani Dr.  Blauvelt, NY 10913 Page 17 of 178
GF-147 Phone: 800-526-0288 PRI: 10/28/2014
CHAPTER 2: INSTALLATION
2.1 INTRODUCTION
This Chapter provides the descriptions and procedures necessary to unpack, inspect and install
AERCO RECON Water Heater Models RECON500 and RECON1000.
2.2 RECEIVING THE UNIT
Each RECON Water Heating System is shipped as a single crated unit. The shipping weight is
approximately
1000 pounds. The unit must be moved with the proper rigging equipment for
safety to avoid equipment damage. The unit should be completely inspected for evidence of
shipping damage and shipment completeness at the time of receipt from the carrier and before
the bill of lading is signed.
NOTE
AERCO is not responsible for lost or damaged freight. Each unit
has a Tip-N-Tell indicator on the outside of the crate. This
indicates if the unit has been turned on its side during shipment. If
the Tip-N-Tell indicator is tripped, do not sign for the shipment.
Note the information on the carrier’s paperwork and request a
freight claim and inspection by a claims adjuster before
proceeding. Any other visual damage to the packaging materials
should also be made clear to the delivering carrier.
2.3 UNPACKING
Carefully unpack the unit taking care not to damage the unit enclosure when cutting away
packaging materials
After unpacking, closely inspect the unit to make sure there is no evidence of damage not
indicated by the Tip-N-Tell indicator. Notify the freight carrier immediately if any damage is
detected.
The following accessories come standard with each unit and are either packed separately within
the unit’s shipping container or are factory installed on the unit:
 Supply Manifold
 ASME Pressure and Temperature Relief Valve
 Condensate Drain Trap
 1 1/4” Gas Supply Shutoff Valve
If the RECON Water Heater is equipped for use with the AERCO Water Heater Management
(WHM) system, an actuator-controlled ball valve must be ordered as a separate line item.
When optional accessories are ordered, they may be packed within the unit’s shipping
container, factory installed on the unit, or packed and shipped in a separate container. Any
standard or optional accessories shipped loose should be identified and stored in a safe place
until ready for installation or use.