Altera Arria V Avalon-MM - Manual (Page 32)

tx_out0[<n>-1:0]
rx_in0[<n>-1:0]
1-Bit Serial
CraReadData_o[31:0]
CraWaitRequest_o
CraByteEnable_i[3:0]
CraChipSelect_i
CraAddress_i[13:0]
CraRead_i
CraWrite_i
CraWriteData_i[31:0]
TxsWriteData_i[<w>-1:0]
TxsBurstCount_i[6 or 5:0]
TxsChipSelect_i
TxsRead_i
TxsWrite_i
TxsAddress_i[<w>-1:0]
TxsByteEnable_i[<w>-1/8:0]
TxsReadDataValid_o
TxsReadData_o[<w>-1:0]
TxsWaitRequest_o
32-Bit
Avalon-MM
CRA
Slave Port
(Optional)
64- or 128-Bit
Avalon-MM TX
Slave Port
64- or 128-Bit Avalon-MM Interface to Application Layer
Test
test_in[31:0]
simu_mode_pipe
hip_currentspeed[1:0]
RxmWrite_<n>_o
RxmAddress_<n>_o[31:0]
RxmWriteData_<n>_o[<w>-1:0]
RxmByteEnable_<n>_o[<w>-1/8:0]
RxmBurstCount_<n>_o[6 or 5:0]
RxmWaitRequest_<n>_o
RxmRead_<n>_o
RxmReadData_i[<n>[<w> -1:0]
RxmReadDataValid_i<n>
RxmIrq[<m>:0]_i, <m> < 16
64-Bit
Avalon-MM RX BAR
Master Port
reconfig_fromxcvr[<n>69-1:0]
reconfig_toxcvr[<n>45-1:0]
busy_xcvr_reconfig
reconfig_clk_locked
Transceiver
Reconfiguration
txdatak0
txdata0[7:0]
txdetectrx0
txelectidle0
rxpolarity0
txcompl0
powerdown0[1:0]
tx_deemph0
rxdatak0
rxdata0[7:0]
rxvalid0
phystatus0
eidleinfersel0[2:0]
rxelectidle0
rxstatus0[2:0]
sim_ltssmstate[4:0]
sim_pipe_rate0[1:0]
sim_pipe_pclk_in
txswing0
txmargin0[2:0]
PIPE Interface
Simulation Only
8-Bit PIPE
Clocks
npor
nreset_status
pin_perstn
Reset
refclk
coreclkout
CraIrq_o MsiIntfc_o[81:0]
MsiControl_o[15:0]
MsixIntfc_o[15:0]
IntxReq_i
IntxAck_o
Multiple
MSI/MSI-X
derr_cor_ext_rcv
derr_ext_rpl
derr_rpl
dlup
dlup_exit
ev128ns
ev1us
hotrst_exit
int_status[3:0]
ko_cpl_spc_data[11:0]
ko_cpl_spc_header[7:0]
l2_ext
lane_act[3:0]
ltssmstate[4:0]
Hard IP
Status
Hard IP
Status
Extension
pld_clk_inuse
pme_to_sr
rx_st_bar[7:0]
rx_st_data[127:0]
rx_st_eop
rx_st_err
rx_st_sop
rx_st_valid
serr_out
tl_cfg_add[3:0]
tx_cfg_sts[52:0]
tx_st_ready
Note: Signals listed for BAR0 are the same as those for BAR1–BAR5 when those BARs are enabled in the
parameter editor.
Variations using the Avalon-MM interface implement the Avalon-MM protocol described in the Avalon
Interface Specifications. Refer to this specification for information about the Avalon-MM protocol,
including timing diagrams.
Related Information
Avalon Interface Specifications
32-Bit Non-Bursting Avalon-MM Control Register Access (CRA) Slave Signals
The optional CRA port for the full-featured IP core allows upstream PCI Express devices and external
Avalon-MM masters to access internal control and status registers.
4-2 32-Bit Non-Bursting Avalon-MM Control Register Access (CRA) Slave Signals
UG-01105_avmm
2014.12.15
Altera Corporation Interfaces and Signal Descriptions
Send Feedback