Altera 100G Development Kit, Stratix V GX Edition - Manual (Page 36)

2–28 Chapter 2: Board Components
General User Input/Output
100G Development Kit, Stratix V GX Edition August 2012 Altera Corporation
Reference Manual
Table 2–18 lists the component references and the manufacturing information.
User LEDs
This section describes all user-defined LEDs. For information on board specific or
status LEDs, refer to
“Status Elements” on page 2–19 .
Board references D39 through D42 and D43 through D49 are 12 user LEDs that allow
status and debugging signals to be driven to the LEDs from the designs loaded into
the Stratix V GX device. The LEDs illuminate when a logic 0 is driven, and turns off
when a logic 1 is driven. There is no board-specific function for these LEDs.
Table 2–19 lists the user-defined LED schematic signal names and their corresponding
Stratix V GX pin numbers.
SW4.1 FPGA_USER_DIPSW0 2.5-V CMOS AG12
User-defined DIP switch that connects to
the FPGA device.
SW4.2 FPGA_USER_DIPSW1 2.5-V CMOS BC7
SW4.3 FPGA_USER_DIPSW2 2.5-V CMOS AE13
SW4.4 FPGA_USER_DIPSW3 2.5-V CMOS AG21
SW4.5 FPGA_USER_DIPSW4 2.5-V CMOS AY22
SW4.6 FPGA_USER_DIPSW5 2.5-V CMOS AU9
SW4.7 FPGA_USER_DIPSW6 2.5-V CMOS AM31
SW4.8 FPGA_USER_DIPSW7 2.5-V CMOS AF35
Table 2–17. User-Defined DIP Switch Schematic Signal Names and Functions
Board
Reference
Schematic
Signal Name
I/O Standard
Stratix V GX Device
Pin Number
Description
Table 2–18. Component Reference Input and Ouput Devices
Board Reference Device Description Manufacturer
Manufacturer
Part Number
Manufacturer Website
SW4, SW5 DIP switches Grayhill Corporation 76SB08ST www.grayhill.com
Table 2–19. User-Defined LED Schematic Signal Names and Functions (Part 1 of 2)
Board
Reference
Schematic
Signal Name
I/O Standard
Stratix V GX Device
Pin Number
Description
D39 USER_LED3 2.5-V CMOS —
General-purpose green surface mount
(type 1206) user LEDs. D40 USER_LED2 2.5-V CMOS —
D41 USER_LED1 2.5-V CMOS —
D42 USER_LED0 2.5-V CMOS —