Standard cabling diagram, Dct 5100, Vcr (optional) – ARRIS DCT5100 Installation Manual User Manual
Page 25: Dct5100 installation manual, Figure 3-1 standard vcr cabling, 2 installation
3-2
Installation
DCT5100 Installation Manual
Standard Cabling Diagram
Standard cabling for cable service is connecting the DCT5100 to a VCR. Figure 3-1 illustrates
the basic RF cabling diagram that enables you to record on your VCR the currently tuned
channel. When a VCR is not present, connect the coax cable from the DCT5100 directly to the
CABLE IN connector on the TV. The output from the RF connection will be on channel 3 or 4,
depending on the configuration information coming from the control system.
Figure 3-1
Standard VCR cabling
ETHERNET
USB
HPNA
AUDIO IN
AUDIO
OUT
VIDEO
IR
R
IN
R
L
OUT
S-VIDEO
IEEE 1394
OPTICAL
SPDIF
SPDIF
L
Y
Pb
Pr
TV
Pass Card
SWITCHED
105-125V
60Hz
4A MAX
500W MAX
CONVENIENCE
OUTLET
TO
TV/VCR
CABLE
IN
DCT 5100
CABLE IN
VIDEO IN
AUDIO IN
L
R
VIDEO OUT
AUDIO OUT
L
R
SVIDEO IN
SVIDEO OUT
TV
CABLE IN
VIDEO IN
AUDIO IN
L
R
CABLE OUT
VIDEO OUT
AUDIO OUT
L
R
SVIDEO IN
SVIDEO OUT
VCR (optional)
From cable outlet
The RF connection does not carry stereo for digital channels. To receive stereo on digital
channels, connect the DCT5100 using RCA baseband connectors illustrated later in this section.