ARRIS DCT5100 Installation Manual - Manual (Page 40)

Installation 3-17
DCT5100 Installation Manual
Operational Check
The operational check tests the communication link between the remote control and the
DCT5100. Table 3-3 lists the operational check procedures:
Table 3-3
Operational check
Feature Testing Procedure
Power on Press POWER to turn on the DCT5100.
Tune to the output channel of the DCT5100 (channel 3 or 4).
Channel Selection Scan through the channels using the CHANNEL + or - keys.
Tune to several channels by entering the channel number using the numeric keys.
Volume Control Press VOLUME + or - on the remote control to increase the volume to its upper limit,
lowest level, and to a comfortable level.
Press MUTE to turn the sound off. Press MUTE again to restore the sound.
If the DCT5100 does not operate properly, refer to Section 5, “Troubleshooting”.