Installing the ir blaster, Checking the ir blaster, Plug the mini-pin connector into the – ARRIS DCT5100 Installation Manual User Manual

Page 34: Dct 5100 vcr, Dct5100 installation manual, Figure 3-9 ir blaster installed, Refer to text to locate ir receiver on vcr

Advertising
background image

Installation 3-11

DCT5100 Installation Manual

Installing the IR Blaster

To install the IR Blaster:

1

Fit the transmitter into the mounting bracket (refer to Figure 3-8).

2

Plug the mini-pin connector into the

IR

jack on the rear panel of the DCT5100 rear panel as

illustrated in Figure 3-9:

Figure 3-9
IR Blaster installed

ETHERNET

USB

HPNA

AUDIO IN

AUDIO

OUT

VIDEO

IR

R

IN

R

L

OUT

S-VIDEO

IEEE 1394

OPTICAL

SPDIF

SPDIF

L

Y

Pb

Pr

TV

Pass Card

SWITCHED

105-125V

60Hz

4A MAX

500W MAX

CONVENIENCE

OUTLET

TO

TV/VCR

CABLE

IN

DCT 5100

VCR

Refer to text to locate

IR receiver on VCR

3

Remove the adhesive tape cover from the mounting bracket.

4

Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
careful to route the wire so that it does not prevent loading tapes.

Checking the IR Blaster

The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT5100. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.

Advertising