1 to select access level 3 or configuration level, To select access level 3 or configuration level, 3code – Super Systems 3L Series User Manual
Page 19: Lev 3 goto, 0code, Conf goto, Conf, 4code, Lev1 goto
Series 3L Indicators
19
5.2.1 To Select Access Level 3 or Configuration Level
Do This
The Display You Should See
Additional Notes
1.
From any display press and
hold
for more than 5
seconds
To Select Level 3
The display will pass from the current operating
level, for example,
Lev 1 to Lev 3 as the button
is held down.
(If no button is then pressed for about 50 seconds
the display returns to the HOME display)
2. Press
or
to enter the
passcode for Level 3
The default code is 3:
If an incorrect code is entered the display reverts to
‘g o t o ’.
If a correct code is entered the indicator is now in the
level 3 will then revert to the HOME display
3.
When the
LEV3 GOTO view is
shown, as in paragraph 1
above, press
to select
‘
Conf’
To Select Configuration
level
Note:
must be pressed quickly before the
indicator requests the code for level 3
4. Press
or
to enter the
passcode for Configuration
level
The default code is 4:
If an incorrect code is entered the display reverts to
‘g o t o ’.
If a correct code is entered the indicator is now in
Configuration level will now show
Conf
5.
Press and hold
for more
than 3 seconds
6. Press
to select the
required level—for example,
LEV 1
To Return to a Lower Level
The choices are:
LEv 1 Level 1
LEv 2 Level 2
LEv 3 Level 3
ConF Configuration
It is not necessary to enter a code when going from
a higher level to a lower level.
Alternatively, press
and scroll to the A c c e s list
header, then press
to select the required level.
The display will then flash ‘
ConF’ for a few seconds
and the indicator will then go through its start up
sequence, starting in the level selected.
Do not power down while
Conf is flashing. If a
power down does occur an error message will
appear – see section 9.4 ‘Diagnostic Alarms’
A special case exists if a security code has been
configured as ‘0’ If this has been done it is not
necessary to enter a code and the indicator will enter
the chosen level immediately.
When the indicator is in configuration level the
ACCESS list header can be selected from any view by
holding down the
button for more than 3 seconds.
Then press
again to select ‘
ACCES’
3
code
Lev 3
goto
0
code
Conf
goto
0
code
Conf
4
code
Conf
goto
Lev1
goto