H3C Technologies H3C S10500 Series Switches User Manual
Layer 2 - lan switching configuration guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Title Page
- Preface
- Contents
- Ethernet interface configuration
- Ethernet interface overview
- Ethernet interface naming conventions
- General configuration
- Configuring basic settings of an Ethernet interface or subinterface
- Configuring an Ethernet interface
- Configuring an Ethernet subinterface
- Shutting down an Ethernet interface or subinterface
- Configuring flow control on an Ethernet interface
- Configuring link change suppression on an Ethernet interface
- Configuring loopback testing on an Ethernet interface
- Configuring the link mode of an Ethernet interface
- Configuring jumbo frame support
- Configuring a Layer 2 Ethernet interface
- Layer 2 Ethernet interface configuration task list
- Configuring a port group
- Setting speed options for auto negotiation on an Ethernet interface
- Configuring storm suppression
- Setting the statistics polling interval
- Enabling loopback detection on an Ethernet interface
- Setting the MDI mode of an Ethernet interface
- Testing the cable connection of an Ethernet interface
- Configuring storm control on an Ethernet interface
- Setting the MTU for a Layer 3 Ethernet interface or subinterface
- Displaying and maintaining an Ethernet interface or subinterface
- Loopback and null interface configuration
- MAC address table configuration
- Overview
- Configuring the MAC address table
- Displaying and maintaining MAC address tables
- MAC address table configuration example
- MAC Information configuration
- Ethernet link aggregation configuration
- Overview
- Ethernet link aggregation configuration task list
- Configuring an aggregation group
- Configuring an aggregate interface
- Configuring the description of an aggregate interface or subinterface
- Configuring the MTU of a Layer 3 aggregate interface or subinterface
- Enabling link state traps for an aggregate interface
- Setting the minimum number of Selected ports for an aggregation group
- Shutting down an aggregate interface
- Restoring the default settings for an aggregate interface
- Configuring load sharing for link aggregation groups
- Enabling link-aggregation traffic redirection
- Displaying and maintaining Ethernet link aggregation
- Ethernet link aggregation configuration examples
- Port isolation configuration
- Spanning tree configuration
- STP
- RSTP
- PVST
- MSTP
- Protocols and standards
- Spanning tree configuration task list
- Configuring the spanning tree
- Setting the spanning tree mode
- Configuring an MST region
- Configuring the root bridge or a secondary root bridge
- Configuring the device priority
- Configuring the maximum hops of an MST region
- Configuring the network diameter of a switched network
- Configuring spanning tree timers
- Configuring the timeout factor
- Configuring the maximum port rate
- Configuring edge ports
- Configuring path costs of ports
- Configuring the port priority
- Configuring the port link type
- Configuring the mode a port uses to recognize/send MSTP packets
- Enabling the output of port state transition information
- Enabling the spanning tree feature
- Performing mCheck
- Configuring Digest Snooping
- Configuring No Agreement Check
- Configuring protection functions
- Displaying and maintaining the spanning tree
- Spanning tree configuration examples
- BPDU tunneling configuration
- VLAN configuration
- Super VLAN configuration
- Isolate-user-VLAN configuration
- Voice VLAN configuration
- GVRP configuration
- QinQ configuration
- Introduction to QinQ
- QinQ configuration task list
- Configuring basic QinQ
- Configuring selective QinQ
- Configuring the TPID value in VLAN tags
- QinQ configuration examples
- VLAN mapping configuration
- LLDP configuration
- Service loopback group configuration
- Index