RIGOL DG1000Z Series - Manual (Page 13)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter and using instruction of each DG1000Z command
in A-Z order.
Main topics of this chapter:
 :COUNter Commands
 :COUPling Commands
 :DISPlay Commands
 :HCOPy Commands
 IEEE488.2 Common Commands
 :LICense Command
 :LXI Commands
 :MEMory Commands
 :MMEMory Commands
 :OUTPut Commands
 :PA Commands
 :ROSCillator Commands
 :SOURce Commands
 :SYSTem Commands
 :TRIGger Commands
Explanation: In this command system, setting commands relating to the frequency and amplitude
parameters can be sent with units. The units available and the default unit of each parameter are as shown
in the table below.
Parameter Type Units Available Default Unit
Frequency
MHz/kHz/Hz/uHz Hz
Sample Rate
MSa/s、kSa/s、Sa/s、uSa/s Sa/s
Amplitude
Vpp/mVpp/Vrms/mVrms/dBm
Vpp/Vrms/dBm (depend on the
parameter to be set)
Offset
V
DC
/mV
DC
V
DC
High Level/Low Level
V/mV V
Time
s/ms/us/ns s
Phase
° °
Duty Cycle/
Modulation Depth/
Brightness/
Contrast
% %
Impedance
Ω Ω