RIGOL DG1000Z Series - Manual (Page 208)

RIGOL Chapter 2 Command System
2-196 DG1000Z Programming Guide
:SYSTem:COMMunicate:LAN:STATic[:STATe]
Syntax :SYSTem:COMMunicate:LAN:STATic[:STATe] {ON|1|OFF|0}
:SYSTem:COMMunicate:LAN:STATic[:STATe]?
Description Turn on or off the ManualIP configuration mode.
Query the status of the ManualIP configuration mode.
Parameter Name Type Range Default
{ON|1|OFF|0} Bool ON|1|OFF|0 OFF
Explanation  In ManualIP mode, the LAN parameters of the signal generator, e.g. IP address,
are defined by users.
 If all the three IP configuration modes are “On”, the priority of parameters
configuration from high to low is “DHCP”, “AutoIP” and “ManualIP”. Therefore,
to enable the AutoIP configuration mode, “DHCP” and “AutoIP” must be set to
“Off”.
 The three IP configuration modes cannot be set to “Off” at the same time.
 After sending this command, the new settings will only take effect when
the :SYSTem:COMMunicate:LAN:APPLy command is executed to apply the
current network parameters.
Return Format The query returns ON or OFF.
Example :SYST:COMM:LAN:STAT ON /*Turn on the ManualIP configuration mode*/
:SYST:COMM:LAN:STAT? /*Query the status of the ManualIP configuration
mode and the query returns ON */
Related
Command
:SYSTem:COMMunicate:LAN:APPLy
:SYSTem:COMMunicate:LAN:UPDate
Syntax :SYSTem:COMMunicate:LAN:UPDate
Description Store all the modifications of the LAN setting to the non-volatile memory and
restart the LAN drive program using the updated setting.
Explanation  You must send this command after modifying the DHCP, DNS, gateway, host
name, IP address and subnet mask settings.
 Please finish all the modifications of the LAN setting before sending this
command.
:SYSTem:COMMunicate:USB:INFormation?
Syntax :SYSTem:COMMunicate:USB:INFormation?
Description Query the USB information of the instrument.
Return Format The query returns a string, for
example, :USB0::0x1AB1::0x0642::DG1ZA000000001::INSTR.