RIGOL DG1000Z Series - Manual (Page 89)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-77
[:SOURce[<n>]]:APPLy:RAMP
Syntax [:SOURce[<n>]]:APPLy: RAMP
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum
[,<offset>|DEFault|MINimum|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description Set the waveform of the specified channel to ramp waveform with the specified
frequency, amplitude, offset and phase.
Parameter Name Type Range Default
[<n>] Discrete 1|2 1
<freq> Real 1uHz to 1MHz 1kHz
<amp> Real Refer to the “Explanation” 5Vpp
<offset> Real Refer to the “Explanation” 0V
DC
<phase> Real 0° to 360° 0°
Explanation  When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
 The range of <amp> is limited by the “Impedance” ( :OUTPut[<n>]:IMPedance
or :OUTPut[<n>]:LOAD ) and “Frequency/Period” settings. The range of <offset>
is limited by the “Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:RAMP 100,1,2,3 /*Set the waveform of CH1 to ramp waveform with
100Hz frequency, 1Vpp amplitude, 2V
DC
offset
and 3° start phase*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD