Source[<n>]]:apply:user – RIGOL DG1000Z Series User Manual
Page 93
RIGOL
DG1000Z Programming Guide
2-81
[:SOURce[<n>]]:APPLy:USER
Syntax
[:SOURce[<n>]]:APPLy:USER
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum
[,<offset>|DEFault|MINimum|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Set the waveform of the specified channel to arbitrary waveform (in frequency output
mode) with the specified frequency, amplitude, offset and phase.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<freq>
Real
1uHz to 20MHz
1kHz
<amp>
Real
Refer to the “Explanation”
5Vpp
<offset>
Real
Refer to the “Explanation”
0V
DC
<phase>
Real
0° to 360°
0°
Explanation
When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
This command only sets the arbitrary waveform parameters of the channel and
does not set the arbitrary waveform type. The default arbitrary waveform is Sinc.
[:SOURce[<n>]]:FUNCtion[:SHAPe]
waveform of the specified channel to the desired arbitrary waveform.
The range of <amp> is limited by the “Impedance” (
) and “Frequency/Period” settings. The range of <offset>
is limited by the “Impedance” and “Amplitude/High Level” settings.
Example
:SOUR1:APPL:USER 100,1,2,3 /*Set the waveform of CH1 to arbitrary waveform
(in frequency output mode) with 100Hz
frequency, 1Vpp amplitude, 2V
DC
offset and 3°
start phase*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD
[:SOURce[<n>]]:FUNCtion[:SHAPe]