RIGOL DG1000Z Series - Manual (Page 88)

RIGOL Chapter 2 Command System
2-76 DG1000Z Programming Guide
[:SOURce[<n>]]:APPLy:NOISe
Syntax [:SOURce[<n>]]:APPLy:NOISe
[<amp>|DEFault|MINimum|MAXimum[,<offset>|DEFault|MINimum|MAXimum]]
Description Set the waveform of the specified channel to noise with the specified amplitude and
offset.
Parameter Name Type Range Default
[<n>] Discrete 1|2 1
<amp> Real Refer to the “Explanation” 5Vpp
<offset> Real Refer to the “Explanation” 0V
DC
Explanation  When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
 The range of <amp> is limited by the “Impedance” ( :OUTPut[<n>]:IMPedance
or :OUTPut[<n>]:LOAD ) setting. The range of <offset> is limited by the
“Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:NOIS 1,2 /*Set the waveform of CH1 to noise with 1Vpp amplitude
and 2V
DC
offset*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD
[:SOURce[<n>]]:APPLy:PULSe
Syntax [:SOURce[<n>]]:APPLy:PULSe
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum
[,<offset>|DEFault|MINimum|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description Set the waveform of the specified channel to pulse with the specified frequency,
amplitude, offset and phase.
Parameter Name Type Range Default
[<n>] Discrete 1|2 1
<freq> Real 1uHz to 25MHz 1kHz
<amp> Real Refer to the “Explanation” 5Vpp
<offset> Real Refer to the “Explanation” 0V
DC
<phase> Real 0° to 360° 0°
Explanation  When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
 The range of <amp> is limited by the “Impedance” ( :OUTPut[<n>]:IMPedance
or :OUTPut[<n>]:LOAD ) and “Frequency/Period” settings. The range of
<offset> is limited by the “Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:PULS 100,3,2,1 /*Set the waveform of CH1 to pulse waveform with
100Hz frequency, 3Vpp amplitude, 2V
DC
offset
and 1° start phase*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD