RIGOL DG1000Z Series - Manual (Page 201)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-189
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
Syntax :SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <integer>
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess?
Description Set the GPIB address of the instrument.
Query the GPIB address of the instrument.
Parameter Name Type Range Default
<integer> Integer 0 to 30 2
Explanation To use the GPIB interface, make sure that your PC has installed the GPIB card. Then,
connect the USB terminal of the USB-GPIB interface converter to the USB Host
interface at the front panel of the signal generator and connect the GPIB terminal of
the USB-GPIB interface converter to the GPIB card terminal of the PC.
Return Format The query returns the GPIB address in scientific notation with 7 effective digits, for
example, 7.000000E+00 (the GPIB address is 7).
Example :SYST:COMM:GPIB:ADDR 7 /*Set the GPIB address of the instrument to 7*/
:SYST:COMM:GPIB:ADDR? /*Query the GPIB address of the instrument and
the query returns 7.000000E+00*/
:SYSTem:COMMunicate:LAN:APPLy
Syntax :SYSTem:COMMunicate:LAN:APPLy
Description Apply the current network parameters.
Explanation After setting the LAN parameters, the new settings will only take effect when this
command is executed.