RIGOL DG1000Z Series - Manual (Page 85)

Chapter 2 Command System RIGOL
DG1000Z Programming Guide 2-73
[:SOURce[<n>]]:APPLy:ARBitrary
Syntax [:SOURce[<n>]]:APPLy:ARBitrary
[{<sample_rate>|DEFault|MINimum|MAXimum}
[,{<amplitude>|DEFault|MINimum|MAXimum}[,{<offset>|DEFault|MINimum|MA
Ximum}]]]
Description Set the waveform of the specified channel to arbitrary waveform with the specified
sample rate, amplitude, offset and start phase (in sample rate output mode).
Parameter Name Type Range Default
[<n>] Discrete 1|2 1
<sample_rate> Real 1uSa/s to 60MSa/s 20MSa/s
<amplitude> Real
Refer to the
“Explanation”
5Vpp
<offset> Real
Refer to the
“Explanation”
0V
DC
Explanation  When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
 This command only selects and sets the arbitrary waveform parameters of the
channel and does not set the arbitrary waveform type. The default arbitrary
waveform is Sinc. You can send the [:SOURce[<n>]]:FUNCtion[:SHAPe]
command to select the desired arbitrary waveform for specified channel.
 The range of <amplitude> is limited by the “Impedance”
( :OUTPut[<n>]:IMPedance or :OUTPut[<n>]:LOAD ) setting. The range of
<offset> is limited by the “Impedance” and “Amplitude/High Level” settings.
Example :SOUR1:APPL:ARB 100,1,2 /*Set the waveform of CH1 to arbitrary waveform
with 100Sa/s sample rate, 1Vpp amplitude and
2V
DC
offset*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD
[:SOURce[<n>]]:FUNCtion[:SHAPe]