Source[<n>]][:mod]:am:state – RIGOL DG1000Z Series User Manual
Page 133
RIGOL
DG1000Z Programming Guide
2-121
[:SOURce[<n>]][:MOD]:AM:STATe
Syntax
[:SOURce[<n>]][:MOD]:AM:STATe {ON|1|OFF|0}
[:SOURce[<n>]][:MOD]:AM:STATe?
Description
Turn on or off the AM modulation function of the specified channel.
Query the on/off status of the AM modulation function of the specified channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
{ON|1|OFF|0}
Bool
ON|1|OFF|0
OFF
Explanation
AM (Amplitude Modulation): the amplitude of the carrier waveform changes with
the transient voltage of the modulating waveform.
The AM carrier waveform could be Sine, Square, Ramp or Arbitrary waveform
(except DC). The default is Sine. Pulse, Noise and DC in the arbitrary waveform
could not be used as carrier waveform. The different settings of various
parameters (such as the frequency, amplitude, offset and start phase) of the
carrier waveform will influence the AM modulated waveform.
When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
If the sweep function (
) or burst function
) is currently enabled, it will be disabled
automatically when the modulation function is turned on.
If the harmonic function (
[:SOURce[<n>]]:HARMonic[:STATe]
) is currently
enabled, the modulation function cannot be turned on (namely the harmonic
cannot be modulated).
Return Format
The query returns ON or OFF.
Example
:SOUR1:AM:STAT ON /*Turn on the AM modulation function of CH1*/
:SOUR1:AM:STAT? /*Query the on/off status of the AM modulation function of
CH1 and the query returns ON*/
Related
Commands
[:SOURce[<n>]]:BURSt[:STATe]
[:SOURce[<n>]]:HARMonic[:STATe]