Roland VR-6HD Direct Streaming AV Mixer - Manual (Page 26)

26
Video Operations
Capturing a Still Image from Input/Output
Video
Here’s how to capture a still image from the input/output video.
1 . [MENU] button
Ó
“VIDEO”
Ó
select “CAPTURE IMAGE”, and
press the [VALUE] knob.
The CAPTURE IMAGE screen appears.
2 . Touch the screen to select the save destination memory
(STILL 1–16) for the still image.
* If you decide to cancel, press the [EXIT] button.
3 . Touch the screen to select the input/output video to
capture.
The capture is executed. When the operation is finished, the message
“COMPLETED” appears.
4 . Press the [MENU] button to exit the operation.
MEMO
¹ You can set the method of saving still images to “temporarily save”.
When you turn off the power, the captured still image is deleted.
From the [MENU] button
Ó
“STILL IMAGE”, set “SAVE TO INTERNAL
STORAGE” to “DISABLE”, and then capture the image.
¹ If you capture when HDCP (p. 18) is on, the still image that is
created is handled in the same way as HDCP-protected video. It
cannot be used if HDCP is off.
Outputting a Loaded Still Image
You can assign a still image to the VIDEO SWITCHER [1]–[6] buttons and
output it in the same way as with video, or momentarily stop the final
output to output the still image.
* When outputting a still image (.png) with an alpha channel, the alpha
channel (transparency) data is ignored.
Assigning a Still Image to the VIDEO SWITCHER
Buttons
A still image loaded into this unit can be assigned to the VIDEO SWITCHER
[1]–[6] buttons, and output in the same way as video.
1 . Load a still image into this unit as described by the
following procedures.
Ø
“Loading a Still Image from a Storage” (p. 25)
Ø
“Capturing a Still Image from Input/Output Video” (p. 26)
2 . Assign the still image to a VIDEO SWITCHER button by
following the steps in “Assigning Video Sources” (“Assigning
Video Sources” (p. 15)).
3 . Follow the steps in “Switching the Video” (“Switching the
Video” (p. 19)) to output the still image.
Inserting a Still Image in the Final Output
You can pause the final output, and output a still image of your choice as
a cut.
Still images can be directly output without being assigned to the VIDEO
SWITCHER buttons.
* The same still image as the final output is also output to the preview.
Use the following methods to output still images.
Operating the USER buttons on the dashboard
Ø
“Using the dashboard” (p. 84)
Using a footswitch
Ø
“Using a Footswitch” (p. 88)
Using an expression pedal
Ø
“Using an Expression Pedal” (p. 89)
Inputting an external control signal (GPI)
Ø
“Inputting a Control Signal” (p. 90)
MEMO
Outputting a still image with a fade-in effect
Use the [OUTPUT FADE] button to add a fade-in effect and output the
still image.
Assign a still image to the AUX bus and edit the function for the
[OUTPUT FADE] button as shown below. (p. 138)
From the [MENU] button
Ó
“SYSTEM”
Ó
, set “OUTPUT FADE ASSIGN VIDEO”
to “AUX”.