Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 19)

19
• Right-click the meter icons that appear in the status
viewer, and select [Property] in the context menu
that appears.
• Right-click the meter icons that appear in the simple
status viewer, and select [Property] in the context
menu that appears.
3
Configure the settings in the [Property] window.
Changes to the settings are sent to receiver channels
and transmitters immediately and applied.
For details on the settings in the [Property] window, see
“[Property] Window” on page 45.
Controlling devices from the [Property
List] tab of the sub window
Perform the following to control devices from the
[Property List] tab of the sub window.
1
Place a check mark next to [Online monitoring and
control] in the [Device] menu.
The system enters online mode, and the receivers are
automatically detected and added to the device list
window.
2
Click the [Property List] tab in the sub window.
The [Property List] tab appears.
Receiver channels that are registered to the status
viewer appear in the [Property List] tab.
If the receiver channel for which you want to configure
settings does not appear in the [Property List] tab,
display the page on which the receiver channel is
registered in the status viewer, or register the receiver
channel to the status viewer.
For details on changing the page displayed in the
status viewer, see “Status Viewer and Meter Icons” on
page 28.
For details on how to register receiver channels to the
status viewer, see “To monitor a particular set of
receiver channels” on page 14.