Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 48)

48
This function is not supported by the DWR-R01D and
DWR-R02D.
GP/CH : Displays the frequency group and channel
configured for the receiver channel.
Frequency : Displays the frequency configured for the
receiver channel.
… : Press this button to display the [Group/Channel
Setting] dialog box. You can select the reception
frequency from the channel plan configured for the
receiver in the [Group/Channel Setting] dialog box.
Active Channel Scan : Press this button to execute the
receiver’s active channel scan function. You can select the
channel for receiving from the detected channels.
Clear Channel Scan : Press this button to execute the
receiver’s clear channel scan function. You can select the
channel for receiving from the detected channels.
Encryption : Configure settings for the receiver’s
encrypted communication function.
Codec mode: Configure settings for the receiver’s codec
mode.
This function is not supported by the DWR-R01D and
DWR-R02D.
BAL Out Level : Configure settings for the receiver’s
analog audio output level.
This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
Main Out Level: Adjusts the receiver’s main out level.
This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
UNBAL Out ATT : Configure attenuator settings for the
UNBALANCED OUTPUT 1/2 connector.
This function is not supported on the DWR-R01D.
Ground Lift : Configure whether to connect the
GROUND (XLR 1 pin) of the BALANCED OUTPUT 1/2
connector to a chassis GROUND. You can avoid hum,
buzz, and other noise caused by GROUND LOOP by
selecting [LIFT] to lift GROUND (XLR 1 pin) from the
chassis GROUND.
This function is not supported on the DWR-R01D.
AF Output: Controls the audio output for the receiver
channel. When [MUTING] is selected, audio output
muting will be enabled for the respective receiver channel.
While muting is enabled, the “muting” indicator on the
AF/PEAK level meter will blink red. When
[UNMUTING] is selected, audio output muting will be
disabled for the respective receiver channel.
This function is available under the following conditions.
DWR-R01D: Version 1.26 or later
DWR-R02D: Version 1.06 or later
Search TX: Makes the screens for transmitters that are
paired with the receiver blink.
• This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
• This function is only available on combinations of 3rd
generation or later digital wireless receivers (such as the
DWR-R03D) and digital wireless transmitters (such as
the DWT-B03R). In addition, when using an RMU-01
for Cross Remote connection, the RMU-01 must be
version 1.27 or later.
2 [Transmitter] menu
Transmitter Type : In online mode, this setting cannot be
changed. Specify the model of the transmitter paired with
the receiver in offline mode.
Transmitter Name : Sets the name for the transmitter.
Power save : Configure settings for the transmitter’s
power-saving function.
RF Power : Configure settings for the transmitter’s
transmitted power.
• If the maximum transmission power setting of the
transmitter is changed, execute pairing. It may not be
possible to set the transmission power using the wireless
remote control function.
• On 3rd-generation or later digital wireless transmitters
(such as the DWT-B03R), [RF Power] cannot be set to a
Note
Note
Note
Note
Note
Note
Note
Notes
Notes