Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 44)

44
Unlit : The input level of the audio signal is less than
–20 dBFs.
1 bar lit : The input level of the audio signal is –20 dBFs
or more and less than –10 dBFs.
2 bars lit : The input level of the audio signal is –10 dBFs
or more and less than –3 dBFs.
3 bars lit : The input level of the audio signal is –3 dBFs
or more.
M Battery condition display
Indicates the transmitter’s battery condition.
The display varies depending on the transmitter model.
• When receiving radio waves from models other than the
DWT-B03R digital wireless transmitter, this indicates
the remaining battery charge of the transmitter in 8 levels
based on metadata received by the receiver from the
transmitter. When the remaining charge is low, the
battery icon turns red.
• When receiving radio waves from the DWT-B03R
digital wireless transmitter, this functions according to
the BATTERY REMAIN setting of the transmitter.
When set to ICON: Indicates the remaining battery
charge of the transmitter in 8 levels based on metadata
received by the receiver from the transmitter. When the
remaining charge is low, the battery icon turns red.
When set to PERCENT: Indicates the remaining
battery charge of the transmitter as a percentage based on
metadata received by the receiver from the transmitter.
When the remaining charge is low, the battery icon turns
red.
When set to TIME: Indicates the remaining operating
time of the transmitter based on metadata received by the
receiver from the transmitter.
N Auto Frequency change status display
Displays the status of the receiver’s AUTO FREQ
CHANGE setting.
HOST : Displayed when the receiver is operating as the
HOST. It scans the RF spectrum for a good frequency for
use by a CLIENT.
CLIENT : Displayed when the receiver finds the HOST
and is operating as a CLIENT. Depending on the RF
environment of the transmitter, the frequency
automatically switches to the viable frequency detected by
the HOST.
The display flashes if the HOST cannot be found.
This function is available only on the DWR-R03D version
1.20 or later.
[BC-DWX Viewer] Tab
The [BC-DWX Viewer] tab displays BC-DWX1 battery
chargers detected by Wireless Studio (sorted by IP
address) and allows you to monitor and control each
BC-DWX1.
Monitoring: Display the charge statuses of batteries and
error occurrences.
Control: Switch the charge mode and enables indicators
for identifying BC-DWX1 units.
A Name
Displays the name of the battery charger.
B CHG Mode
Allows you to configure the charge mode.
C Slot number and remaining batter indicator / error
display
Displays the statuses of slots 1 and 2 as follows.
• When batteries are inserted
When no error has occurred: Remaining battery
indicator
When an error or warning has occurred: Error or warning
icon
• When batteries are not inserted
No Battery
D [Blink] button
Enables indicators for identifying each slot.
Note
1 2
3
4