Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 32)

32
Other event messages
The messages that appear are as follows.
[Property List] Tab
This tab displays a list of settings for the receiver channels
displayed in the status viewer. When you change the page
displayed in the status viewer, this change is also reflected
in the settings displayed in the [Property List] tab.
You can change setting values in the [Property List] tab by
selecting the cells. By selecting multiple cells, you can
change the setting values for multiple receiver channels as
a group.
a [Name] field
Displays the name of the page currently displayed in the
status viewer.
b Settings list
Displays a list of settings for the device displayed in the
status viewer.
You can change setting values by selecting the cells in the
list. When you click a cell and select a value from the list
of options that appears, the setting value is applied to the
respective receivers and transmitters.
Cells displayed in yellow indicate that the wireless remote
control signal strength is low or that setting values failed to
be applied for the respective receiver channels. In such
cases, try configuring the settings again. When the settings
are successfully configured, the cell will change from
yellow to the standard color. You can also clear the yellow
indications by clicking the [Clear Indication] button.
ANT DC OUT terminal
is over current. There has been a current
overload at the ANTENNA a/b IN
connector.
Transmitter’s battery
level is low. The transmitter’s battery is weak.
Receiver cannot decrypt
the encrypted signal. Encrypted transmission settings
on the receiver and the
transmitter do not match.
RF level is excessive. The signal reception level is
excessively high.
RF level is low. The signal reception level has
dropped.
Quality level is low. The quality of received audio data
is deteriorated.
Audio signal is reached
clipping level. The audio input level on the
transmitter is excessive.
Communication time-
out occurred. The number of retries has
exceeded the limit and a timeout
error has occurred.
CPU EEPROM error
occurred. A CPU EEPROM error has
occurred.
RF EEPROM error
occurred. An RF circuit EEPROM error has
occurred.
Receiver’s codec mode
is mismatched with
Transmitter’s codec
mode. The codec modes of the
transmitter and receiver do not
match.
Message Meaning
Communication was
enabled. Recovered from a communication
timeout.
The process of loading
settings was finished. Loading of settings is complete.
The process of loading
settings was failed. Loading of settings has failed.
The process of
changing in Online
mode was finished. Transition into online mode is
complete.
The process of
changing in Online
mode was failed. Transition into online mode has
failed.
The process of
changing in Offline
mode was finished. Transition into offline mode is
complete.
The process of
searching devices was
finished. Search processing is complete.
The number of new
DWR: XX XX number of DWR units have
been newly detected.
The number of new
RMU: XX XX number of RMU units have
been newly detected.
Message Meaning
The number of new
BC:XX XX number of BC units have
been newly detected.
Battery charger
detected low
temperature. The battery charger detected an
abnormal temperature (low
temperature).
Battery charger
detected high
temperature. The battery charger detected an
abnormal temperature (high
temperature).
Battery charger
detected overvoltage. The battery charger detected an
overvoltage condition.
Charging error
occurred. A charging error occurred.
Wireless Studio
detected region error. A receiver for a different region
was detected.
Message Meaning
1 3 4 5 2