Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 33)

33
You can also select multiple cells using any of the
following methods. When multiple cells are selected, the
setting values for the selected receiver channels can be
changed simultaneously.
• Click and drag over the cells.
• Click the cells one at a time while holding down the Ctrl
key.
• Click two cells that are not neighboring while holding
down the Shift key.
c Displayed setting items checkboxes
Select whether to display or hide setting items in the
[Property] window by category.
For details on the [Property] window, see “[Property]
Window” on page 45.
Utility : Select this to display the [Utility] tab in the
[Property] window.
Receiver : Select this to display the [Receiver] menu in the
tabs for channels 1 and 2 in the [Property] window.
Transmitter : Select this to display the [Transmitter] menu
in the tabs for channels 1 and 2 in the [Property] window.
Remote : Select this to display the [Remote] menu in the
tabs for channels 1 and 2 in the [Property] window.
d [Unlock Settings] / [Lock Settings] button
When setting modification is disabled due to the [Setting
lock] function, click this button and enter the password to
temporarily enable setting modification.
Click the button again to relock settings.
For details on the [Setting lock] function, see“[Setting
lock] Window” on page 55.
e [Clear Indication] button
Clears the yellow indications that appear when setting
values for receivers and transmitters fail to be applied.
Use this when the indications are no longer necessary.
Changing settings for multiple receiver channels
as a group
1
Select the GP/CH item for multiple receiver channels
in the [Property List] tab.
[…] appears for the cells.
2
Click […].
The [GP/CH Selection] dialog box appears.
3
Select a frequency group under [GP] in the upper-right
part of the [GP/CH Selection] dialog box.
A list of frequency channels that belong to the selected
frequency group appears under the [Channel] column.
4
Select the receiver channel for which you want to
change settings from the receiver channel list in the
left part of the [GP/CH Selection] dialog box.
5
Select the frequency channel that you want to assign to
the selected receiver channel from the [Channel]
column, and click [<--].
The group and channel are assigned to the receiver
channel.
To cancel group and channel assignments, click [-->].
6
Repeat steps 4 to 5 to assign frequency channels to
other receiver channels, and click [OK].
The changed settings are applied.