Sony Underwater Housing for Select RX100-Series Cameras - Manual (Page 47)

47
Band : Selects the frequency band to use.
ANT ATT : Sets the attenuator for the receiver’s antenna
input.
ANT DC Output : Sets the DC power supply for the
antennas connected to the receiver’s ANTENNA a/b IN
connectors.
Diversity: Specifies the receiver’s diversity setting.
• This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
• Some screen displays will change depending on the
[Diversity] setting. For details, see “Effects of the
Diversity Setting on Wireless Studio Displays” on
page 60
.
Monitor Mode: Specifies the receiver’s headphone
monitor setting.
This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
Sync Source : Sets the sync signal source for the receiver.
Delay Adjust : Selects whether to correct differences in
audio delay time that may occur between receiver channels
1 and 2.
Alert function settings : Specifies the conditions under
which to light the ALERT indicator on the receiver. You
can select the following conditions as triggers for lighting
the ALERT indicator.
• RF low (RF level too low)
• RF over (RF level too high)
• QL low (QL too low)
• AF Peak (audio output level too high)
• Transmitter Battery low (remaining battery on
transmitter is low)
• Encryption unmatch (password or encryption key for the
encrypted communication function does not match)
• External word sync unlock (external word clock signal
not synchronized)
• Code mode unmatch (codec modes of transmitters and
receivers do not match)
If lighting of the ALERT indicator is disabled for an item,
warning messages will not be displayed in the alert list
under the [Message Log] tab and [RF Chart Grapher] tab
of Wireless Studio for that item. In addition, such items
will not be recorded in the log file.
QL Alert SENS: Specifies the level at which the quality
of the received signal is determined to be low. If the quality
of the received signal drops below the level specified here,
the ALERT indicator of the digital wireless receiver lights.
The QL Alert SENS function is available for the following
receiver versions.
DWR-R01D: Version 1.29 or later
DWR-R02D: Version 1.09 or later
DWR-R02DN: Version 1.14 or later
DWR-R03D: Version 1.00 or later
Lock: Sets the receiver’s setting lock function.
This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.
Channel tabs 1/2
Displays setting items that are equivalent to those in the
RECEIVER, TRANSMITTER, and RF REMOTE menus
of the receiver.
For details on the setting items in each menu, refer to the
Operating Instructions supplied with the receiver.
1 [Receiver] menu
BAND: Specifies the frequency band to use.
Notes
Note
Note
Note
Note
1 2
3