Honeywell HERCULINE 2000 - Manual (Page 15)

Specifications
Technical and Operating Specifications
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 7
7/08
HercuLine
®
2002 HercuLine
®
2001 HercuLine
®
2000/2003
Feedback Slidewire emulation - Provides
output voltage ratiometric to
shaft position and
potentiometric to supply voltage
(1 Vdc to 18 Vdc) without a
slidewire. Emulates a 100 ohm
to 1000 ohm slidewire. 10 mA
output maximum.
Communications Modbus RTU or optional HART ™ NA
Operating Temperature –40°C to +75 °C (–40°F to +170 °F) -40°C to +85 °C (-40°F to
+185 °F)
Position sensing Non-contact position sensor 1000 ohm film potentiometer Dual 1000 ohm film
potentiometers
(not on 2003)
Sensitivity 0.2 % to 5 % of 90° span, proportional to deadband NA
Hysteresis Less than 0.4 % of full scale NA
Deadband 0.2 % to 5 % of 90° span, programmable. Shipped at 0.5 % NA
Repeatability 0.2 % of 90° span NA
Repositions
(minimum @ 90 or 150
degree stroke)
Table 1 option –050-
Table 1 option –100-
Table 1 option –200-
Table 1 option –400-
Table 1 option –600- 160
290
450
700
900
120
250
400
400
400 500
Voltage/ Supply
Stability 0.25 % of span with +10/–15 % voltage change NA
Temperature
Coefficient Less than ± 0.030 % of span per degree C for 0 °C to 50 °C
Less than ± 0.05 % of span per degree C for –40 °C to 75 °C
NA
Zero Suppression 90 % of span. NA
Input Filters Selectable spike and low pass filters. NA
Solid State Motor
Control Two triac switches for clockwise or anti-clockwise motor operation.
Transient voltage protection provided. NA
Failsafe operation If input signal exceeds configured input range. Selectable and
adjustable. NA
Direction of Rotation Field programmable Wire swap
Duty Cycle Continuous