Gilson 215 - Manual (Page 31)

2-15
Installation
2
4 Loosen the mounting screw on the Z-arm
mounting bracket and slightly raise the Z-arm.
5 Manually move the liquid handler’s arm so the
Z-arm is centered over the Z-height adjustment
tool.
6 While holding Z-height adjustment tool flat
against the locator plate, use the other hand to
lower the Z-arm until it lightly rests on the
adjustment tool.
7 Tighten the mounting screw on the Z-arm
mounting bracket so the Z-arm is secure.
8 While holding the adjustment tool in place,
slide the Z-arm off the tool. Ensure that the
bottom of the Z-arm lightly rubs against the
adjustment tool as it moves. Repeat steps 4
through 7 until this is true.
9 Store the Z-height adjustment tool.
Final Z-Arm
Adjustment