Sharp UX-5000 - Manual (Page 34)

<P=008>
Example
Batch Page Numbering
This setting is used to change the page numbering of the transmitted document from
simple numbering ("P.1", "P.2", etc.) to batch numbering, which means that a slash
and the total number of pages being sent are added after each page number (for
example, "P. 1/5", "P.2/5", etc.). This allows the receiver to check for any missing
pages.
♦
If you are sending a cover sheet, do not include the cover sheet in the total number
of pages. Your fax will adjust the number to include the cover sheet automatically.
♦
If you need to cancel a batch number entry, remove the document from the feeder
or press the STOP key.
♦
If transmission does not take place within one minute after entering the batch num-
ber, the setting will be canceled.
♦
If the number of pages actually transmitted does not coincide with the batch number
entered, the alarm will sound and PAGE COUNT ERROR will appear in the display.
"PAGE E" will also appear in the "NOTE" column of the Transaction Report if it has
been set to print out.
Step Press these keys: Comments
1
"ENTER # OF PAGE(S)" will appear in the
display.
2
(Example)
Enter the total number of pages (2 digits - "01" to
"99") by pressing the numeric keys.
R
PAGE COUNTER
3 1
Note: For the recipient’s
name to appear, you must
dial using a Rapid Key or
Speed Dial number that has
the name programmed.
SENDING DOCUMENTS
3-8 BASIC OPERATIONS