Sharp UX-5000 - Manual (Page 71)

UX5000U-SFEP YF <P=001>
ENTERING AND USING PROGRAMS
If you frequently perform the same operation involving the same party, you can
program all the steps of the operation into one Program Key. This allows you to
perform the operation by simply pressing that key.
Any Rapid Key which is not already programmed as a Rapid Key or a Group Key can
be used as a Program Key.
♦
You can also include a timer setting in the program to have the operation performed
automatically at a selected time.
♦
To clear a mistake, press the STOP key.
Initial procedure
To program an operation, first perform the following procedure. After you have
completed it, go to the procedure for the specific operation you want to program.
♦
Code numbers are used to set days of the week. Refer to the table below when
making time settings which include a specified day:
Day SUN MON TUE WED THU FRI SAT
Code 0 1 2 3 4 5 6
Step Press these keys: Comments
1
"PROGRAM/GROUP MODE" will appear in the
display.
2
"PROGRAM ENTRY MODE" will appear in the
display.
3 Select SET.
4
(Example)
Select a Program Key by pressing the
appropriate Rapid Key.
5
(Example)
Enter a name for the program (max. of 20
letters). (See "Entering Letters for Names" in
Chapter 2.)
Skip this step if you don’t want to enter a name.
6
7
(Example)
Enter the hour (2 digits: "01" to "12"). If you don’t
want to make a timer setting, go to Step 11.
FUNCTION
S H
… …
P
1
7
A
1
1
START
1 0
SPECIAL FUNCTIONS 4-25