Sharp UX-5000 - Manual (Page 90)

<P=002>
BUSY - The line was busy.
COM.E-0 to COM.E-14 - A telephone line error prevented the transaction. Explanations
of the error numbers are given in the following tables, however, these are primarily for
use by service engineers. In general, you will want to simply try the transaction again. If
necessary, check with the other party to make sure their machine is functioning properly.
CANCEL - Transmission was cancelled because the STOP key was pressed, no
document was in the feeder, or the other machine requested transmission using a
function which your fax does not have.
CANCEL 3 - Confidential transmission was cancelled because the receiving machine
does not have a confidential function, a confidential passcode is not programmed in it,
its memory is full, or it is not a Sharp model.
CANCEL 4 - Confidential transmission was cancelled because an incorrect mailbox
number was entered for a fax machine with confidential mailboxes.
CANCEL 5 - A relay request was not successful because the machine to which the
request was made has no relay function, it is not a Sharp model, or its memory was full.
CANCEL 6 - A relay request was not successful because your machine’s fax number
has not been entered into the relay machine’s list of permitted numbers, an automatic
dialing number not stored in the relay machine was specified, or your fax number has
not been entered in your machine as described in Chapter 2.
Transmission errors
E-0
Able to recognize handshake signal, but it has
errors.
E-1
Cannot recognize the handshake signal from
the receiver side.
E-2 Line disconnected during transmission.
E-3 Line disconnected after modem speed fall-back.
E-4
Line disconnected during multi-page
transmission.
E-6
Cannot recognize the handshake signal for
next page at receiver side.
E-7
No response from receiver side or "disconnect
signal" is received at transmitter side.
E-8
Error was not corrected after the predetermined
number of retries because of an error in a part
of a page.
E-11
Error occurred after or while reception by the
remote (receiving) machine was revealed to be
impossible.
E-12 Error occurred just after fall-back.
E-13
Error occurred after a response to a
retransmission end command was received.
Reception errors
E-0
Able to recognize handshake signal, but it has
errors.
E-1 Line disconnected during reception.
E-2
Cannot recognize the handshake signal from
the transmitter side.
E-3
Cannot recognize the last handshake signal
from the transmitter side.
E-4
Cannot recognize the handshake signal for
next page from the transmitter side in the case
of mode change.
E-5
Cannot recognize the handshake signal for
next page from transmitter side.
E-7
No response from transmitter or "disconnect
signal" is received at receiver side.
E-8
Error occurred upon completion of reception of
all pages.
E-9
Error occurred when mode was changed or
transmission/reception switching was
performed.
E-10
Error occurred during partial page or physical
page reception.
E-11
Error occurred after or during inquiry from the
remote (transmitting) machine as to whether
reception was possible or not.
E-12 Error occurred during or just after fallback.
E-13
Error occurred after retransmission end
command was received.
E-14
Error occurred after voice communication
command was received.
PRINTING OUT REPORTS AND LISTS
6-2 PRINTING OUT REPORTS AND LISTS