Sharp UX-5000 - Manual (Page 87)

<P=005>
Setting 21: JUNK FAX NUMBER CHECK
Press "1" to prevent reception from fax numbers entered in the Anti Junk Fax List. Press "2" to
allow reception from all numbers.
• Factory setting: "2"
Setting 22: ALARM VOLUME
This sets the volume of the beep sound which alerts you to error conditions and informs you
that operations have been completed. Press "1" for high, "2" for middle, "3" for low, or "4" to turn
the alarm off.
• Factory setting: "3"
Setting 23: DIAL MODE
This sets the mode of dialing. Press "1" if you are on a touch-tone line, or "2" if you are on a
pulse dial line. (If you don’t know which type of line you have, try making phone calls with both
settings and see which one works.)
• Factory setting: "1"
Setting 24: QUICK ON LINE
When you transmit a multi-page document, this setting determines whether your fax will dial the
receiving party and begin transmitting while scanning is still in progress, or wait until all pages
have been scanned before dialing. Press "1" to have the fax dial and begin transmission while
scanning is still in progress, or "2" to have it wait until all pages have been scanned.
• Factory setting: "1"
Setting 25: MULTI TTI
If you are using Department Control, you can press "1" to have the department name (the name
corresponding to the department code entered by the operator) appear at the top of each
transmitted document. This will appear in place of the name entered in "Entering Your Name
and Fax Number" in Chapter 2. Press "2" to turn Multi TTI off (the sender’s name entered in
Chapter 2 will be used).
• Factory setting: "2"
Setting 26: BEEP LENGTH
This sets the duration of the beep which signals the end of transmission, reception, or copying.
Press "1" for 3 seconds, "2" for 1 second, or "3" for no beep.
• Factory setting: "1"
Setting 27: TELEPHONE BILLING CODE
If you are using the Department Control function, this setting will allow you to use Department
Codes for telephone billing on a PBX. Press "1" to turn telephone billing on, or "2" to turn it off.
• Factory setting: "2"
If you pressed "1", the BILLING CODE DIAL selection will subsequently appear. Press "1" if
your PBX must receive the billing code before dialing a telephone number, or "2" if it must
receive the billing code after dialling a telephone number. (Refer to your PBX manual or consult
your PBX adminstrator for this information.)
Note: If you select "AFTER" for the BILLING CODE DIAL selection, you must press the
REDIAL key after dialing if you use the handset or the SPEAKER key to dial.
OPTIONAL SETTINGS
OPTION SETTINGS 5-5