Sharp UX-5000 - Manual (Page 59)

or
<P=002>
Serial Polling using a Group Key
If the fax machines you want to poll have all been programmed into one Group Key,
you can poll them by simply pressing that Group Key.
♦
Make sure no documents are in the feeder before you press the Group Key.
Being polled (Memory polling)
To let another fax machine poll your fax, you must first store the document in memory
as shown in the procedure below. Transmission will take place when the other fax
calls your fax and activates polling. You can choose whether to allow polling only
once, or an unlimited number of times. In the latter case, your fax can be used as an
electronic "bulletin board".
♦
Only one document can be stored at a time for memory polling.
♦
If you allow polling only once, the document will be automatically cleared from
memory after polling. If you allow polling an unlimited number of times, the
document will remain in memory until you clear it using the procedure described in
"Clearing a document" which follows.
1
Load the document and set the
reception mode to AUTO (press
FUNCTION, "1", and "1").
••
Set the resolution and/or contrast if de-
sired.
2
Press the FUNCTION key and the "9"
key.
••
MEMORY POLL MODE will appear in
the display.
3
Press "1" to select SET.
4
Press "1" to allow polling to be done
only once, or "2" to allow polling to be
done an unlimited number of times.
9 FUNCTION
1
1 2
FUNCTION
1
1
POLLING
SPECIAL FUNCTIONS 4-13