Schneider Electric Communication Drivers - Manual (Page 109)

ISAWAY driver
109
Procedure To adjust the parameters, proceed in the following manner:
Example of
standard
address
selection The standard address provided by the system is equal to 250 in hexadecimal:
Example of IRQ
selection The interrupt address provided by the system is 10:
Step Action
1 Code the number of the rack which contains the processor.
2 Code the processor position.
3 Code the standard I/O address provided by the operating system with the
micro-switches.
4 Code the interrupt level provided by the operating system with the micro-
switches.
4 5 6 7 8
0
9
1
Note: The jumper must not be set in the IRQ position.
3 5 10 11 15 IRQ