Schneider Electric Communication Drivers - Manual (Page 18)

Serial port
18
How to install the driver
At a Glance Driver installation is a standard installation. It can be launched either:
l from the drivers’ CD-ROM,
l or from disks if the station has no CD-ROM drive.
How to create a
set of disks Use the following procedure to create installation disks:
Preliminary
operations Before installing the new driver, you must check that no other version of this driver
exists on the station.
If a driver does exist, you must delete it before carrying out the new installation.
A previous version can be uninstalled using:
l Drivers Manager software,
l or the Control Panel
→
Add/Remove Programs.
Note: The installation disks are created from the CD-ROM.
Step Action
1 Use a station with a CD-ROM drive.
2 Insert the CD-ROM into the drive.
3 Access the directory of the driver to be copied onto disk.
4 Copy the contents of the DISK1 directory onto a disk. Repeat this step for each
DISK directory.
Note: it is advisable to number the disks.