Schneider Electric Communication Drivers - Manual (Page 21)

Serial port
21
Uni-Telway
parameters The parameters are presented in the following manner:
The Station ID window is used to name the remote device associated with the
driver configuration.
The COM Port window is used to select the communication port used.
The Uni-telway Slave Address window is used to enter:
l the standard slave address of the driver,
l the number of slave addresses used by the driver.
The Modem Communication window is useful when the local station is
communicating via a modem. In this case, this window is used to enter:
l the HAYES string to be sent to the modem in order to initialize it,
l the call number of the remote device,
l the password to be sent to the remote device, if it has been configured with a list
of callers with passwords (e.g. TSX MDM 10 card configured with passwords).
Link Parameters
Station ID
COM Port
Uni-telway Slaves address
Communication Modem
Number Base
Hayes
Tel No.
Password
Advanced Uni-Telway
OK
Modem Used
Cancel
Parameters of the Station
[Default]
COM 1
1 3