Configuration of the operating system – Schneider Electric Communication Drivers User Manual
Page 96
ISAWAY driver
96
Configuration of the operating system
At a Glance
After the driver installation and configuration phase, the operating system shall
recognize the TPCX 57 card and its driver.
Installation
principles
As this card is not automatically recognized by the operating system, the following
phases must be carried out:
Step
Action
1
Select the hardware type:
l
for Windows 98 see How to select the hardware type for Windows 98, p. 97,
l
for Windows 2000 see How to select the hardware type for Windows
2000\XP, p. 100,
l
for Windows NT no operation is required.
2
Configure the parameters of the operating system to recognize the card:
l
for Windows 98 see How to configure hardware parameters for Windows
98, p. 103,
l
for Windows 2000 see How to configure hardware parameters for Windows
2000\XP, p. 105,
l
for Windows NT no operation is required.
3
Switch off the station.
4
Adjust the card parameters: See How to adjust the ISA TPCX 57 card
parameters, p. 108.
l
the standard I/O address,
l
the IRQ interrupt address.
5
Connect the card to the ISA bus.
6
Turn the station back on.
Result: the driver is operational.